The Monoprice HDMI® Extender can extend an HDMI® video signal up to 30 meters over two Cat6 ethernet cables run through the walls. This unit supports all NTSC and PAL video resolutions up to 1080p with 24/36 bit Deep Color. It supports LPCM, Dolby®-AC3, DTS® 7.1, and DSD audio signals. This is a passive device, so no power adapter is needed! The wall plates also feature a built-in IR extender system, with all the necessary hardware, so you can control your equipment from the other room using your regular remote control.

Features:

Supports High Speed HDMI® signals (1080p)

Supports Deep Color

Passive, no power adapter required

Includes IR receiver and transmitter to extend remote control signal

Supports single-band IR signals between 39-45 kHz

IR cables supplied with unit are 4'10" long

FCC and CE Approved

Note: Monoprice strongly recommends the use of minimum 24 AWG HDMI® cables when connecting a device, such as this extender, between the source and destination devices to ensure minimal signal loss and maximum High Speed signal reliability.

Note: Although this extender will work with Cat5e UTP cables, Monoprice STRONGLY recommends using Cat6 STP cabling for anything longer than minimal distances. Cat6 STP cabling will provide the highest reliability and signal integrity to ensure that your installation is trouble-free under all conditions for years to come.

Requires low-voltage mounting brackets (one per wall plate). These are not included!

  Support Files: User's Manual (May 31, 2011)

Connection Diagram (Mar 22, 2011)

 

HDMI, the HDMI Logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries. DTS is a registered trademark and the DTS logos, Symbol, DTS-HD and DTS-HD Master Audio are trademarks of DTS, Inc. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.

Specifications

Data Transfer Speed 6.75Gbps – 10.2Gbps

Supported HDMI® Resolutions 1080p/1080i/720p/576p/576i/480p/480i

Color Support 24 and 36 bit Deep Color

Supported Audio Formats LPCM, Dolby®-AC3, DTS® 7.1, DSD

IR Frequency Range 38 kHz

IR Signal Bands Single

Maximum Output Cable Distance less than 5 meters

Maximum Input Cable Distance less than 5 meters

Operating Humidity Range 5 to 90% RH (no condensation)

Operating Temperature Range -15 to +55 C (5 to 131 F)

Dimensions 114mm x 70mm x 41mm (4.5” x 2.7” x 1.6”)

Regulatory Certification FCC, CE

Question: The picture passing through the extender is constantly flickering or on occasion getting video and audio cutout, what can I do?

Answer: We would recommend to try to run the setup outside the wall just to test. A electrical wire or video cable if inside the wall can cause interference causing flickering or video and audio signal loss. Try rerouting cable paths and distancing devices from sources of interference, such as moving the electrical and other cables away from cables in wall.

Also please test another source device with the extender if using a DVD player try a cable box for example and to also try a different video resolution if trying 1080p try 720 just to test the connectivity.

Question: The IR signal is not transmitting from wall plate to wall plate, what troubleshooting steps should I try?

Answer: Please make sure the IR sensor is in front of the device being controlled to be able to pick up the signal and send back. Make sure all lights on the wall plate are on and active to be sure the wall plate is working properly.