The MST-63-2K features a triple driver design with two pivoting tweeters to offer a broader, richer frequency spectrum to deliver unmatched sonic performance. The woofer is constructed of an advanced glass composite to deliver high fidelity, distortion free audio. The speaker comes with two sets of speaker wire terminals for wiring in two channels to achieve a stereo effect from a single speaker by pivoting the tweeters towards different points in the room and using acoustic reflection.

Features:

• Exotic Glass Composite Woofer for distortion free reproduction.

• Oversized Magnets for more impactful bass.

• Dual Precision Titanium Silk Membrane Dome Tweeters for broad frequency spectrum, sweeter highs and pure sonic clarity.

• Pivoting tweeters allow you to point the acoustics to the prime listening position for a more accurate and immersive sonic experience.

• 40W Nominal and 100W Maximum Power Capacity provide ample headroom so these drivers won't be easily over driven or blown out.

• 8 Ohms Standard Impedance ensure they can be safely driven by even the most modest home theater receivers.

And to install PID# 4619: If you are running a stereo signal to the speaker (like right and left), then hook up each set of speaker wires to a separate terminal on the back of the speaker. So both terminals will be used. Keep the jumper cable set at “standard single speaker stereo”. On one of the speaker terminals only reverse the positive and negative wires, so your positive speaker wire will go to black and your negative will go to red. This will make sure you don’t have phase cancellation problems. If you are sending one channel to the speaker (like center or just left or just right) then put your speaker wire into one of the terminals (does not matter which one) and set the jumper cables to the parallel connection side. It does not matter which terminal side you hook up your speaker wires to. This speaker does not know right or left channel. It will separate them to play stereo, but which is the left and which is the right side, does not matter, because the tweeters face down anyways, so right and left is not important.

6.5 3-WAY IN-CEILING SPEAKERS Impedance: 8 Ohms

Frequency Response: 57 Hz - 20,000 Hz

Power Handling Capacity: 40 Watts x 2 Nominal, 100 x 2 Maximum

Woofer: 6.5" Glass Composite Woofer w/ 13.3oz Magnet and rubber surrounds.

Tweeter: Dual 1" Titanium Silk Membrane Dome (Pivoting)‧20Φ Swivel

Sensitivity: 85 +/- 2db (1.0M/2.83V)

Crossover: 12dB per Octave

Cut-Out Dimensions: 8.07"

Overall Dimensions: 9.4"

Mounting Depth: 4 3/4"

Contents:

2 - 6.5" 3-way In-Ceiling Speaker w/ grill

1 - Installation instructions

1 - Cutout template and paint mask

1 - Grill removal tool

1 - Grill putty

 

Please note that this video shows the specific instructions for installation of PID 4101. However, it is representational of the steps, tools, and types of procedures that would be used for the installation of any in-wall or in-ceiling speaker and is included on this page for reference purposes only.

Note that the price listed in the video was the price for PID 4101 at the time the video was made. Prices can fluctuate up and down based on production costs and the value of the US$ against foreign currencies.